CCD Connector Pinout:

The pinout of the CCD connector is displayed below:

CCD Connector

This connector is compatible with Meade LX50 and LX200 CCD ports. It has the following specifications:

• All signals prefaced by a dash (-) are active low.
  
  
• Outputs can sink up to 10 mA when active, and can withstand 40 vDC when off.
  
  
• +5V is regulated to 20% up to 6 mA, and is diode protected.

http://www.meade.com/manuals/pictor/picapp.html





LX200

 CCD Connector
The CCD Port (10, Fig. 7) allows direct interface from popular aftermarket CCD autoguiding/imaging cameras with their compatible connecting cables to accomplish autoguiding for non-attended astrophotography. The CCD cameras effectively watch a star and detect slight movements. When star movements are detected, signals from the CCD electronics make drive corrections in the LX200, to bring the star to a home position.
Most CCD autoguiding/imaging cameras are supplied with a cable which is compatible with the LX200 port. If your CCD unit does not have a cable, one can be obtained from the CCD manufacturer, or you can make your own cable using the following table of information.


http://www.meade.com/manuals/lx200/f.html#f5






PLANETpro-237では、
1 EAST
2 NORTH
3 SOUTH
4 WEST
5 GND
6 PWR(5V)
となっています。
6ピンは、機種により繋ぐと問題が出るので注意が必要です。